Table of Contents
Advertisement
Chapter 2 Installation
2-1 Inspection
The 4016 Series AC/DC Digital Power Analyzer was carefully inspected before shipment. If
instrument damage has occurred during transport, please inform Prodigit's sales and service
office or representative.
You're 4016 Series AC/DC Digital Power Analyzer was shipped with a power cord for the type
of Terminal blocks used at your location. If the appropriated cord was not included, please
contact your nearest Prodigit sales office to obtain the correct cord. Refer to "check line
voltage "to check the line voltage is 100V~230Vac.
2-2 Check line voltage
The 4016 Series AC/DC Digital Power Analyzer can operation with 100 Vac ~230Vac input as
indicated on the label on the rear panel.
Make sure that the factory check mark corresponds to your nominal line voltage. Skip this
procedure if the label is corrected marked.
2.2.1.
With the 4016 Series AC/DC Digital Power Analyzer power OFF, disconnect the
Power cord.
2.2.2.
Refer the drawing on the rear panel of 4016 Series high power Digital Power
Analyzer in Fig 2-1.
2-3 Fuse Exchange
This product has the power fuse, and exchanges it according to the following procedure.
Never fail to turn off the power of this product, and disconnect the plug of the AC Power
cable.
4016 Series Operation Manual 5
Fig 2-1 4016 Series AC Input Connection
Advertisement
Table of Contents
