Advertisement
Quick Links
Advertisement
Related Manuals for Little Folks Furniture BBD004
Summary of Contents for Little Folks Furniture BBD004
- Page 1 Simple Bunk Bed Code: BBD004 PLEASE READ CAREFULLY & KEEP FOR FUTURE REFERENCE...
-
Page 2: Product Safety
Thank you for buying a piece of furniture Treated properly it should be a faithful servant for years - and we hope you get the same amount of pleasure from it. Before you do please take a few minutes to read these instructions we suggest you carefully unpack everything, lay it out on a clean, flat floor and identify everything on the parts list in these instructions. - Page 3 Parts 4 x supports 2 x upper ends 2 x lower ends 2 x lower rails front safety panel 2 x upper rails rear safety panel ladder Fittings 22 x Large Bolts 2 x mattress base 16 x Bolts 3cm 68 x Screws 3cm 8 x Bolts 2.5cm 8 x Screws 2.5cm...
- Page 4 Making the bed frames. 16 x long Bolts, 16 x Barrel Nuts, an Allen key Push one barrel nut into each mattress rail holes, aligning the slot head to the end hole. Slide each bolt through the bed end holes and into the holes in the end of each mattress rail.
-
Page 5: Fixing The Supports
Fixing the supports You need: 8 x 3cm bolts and an allen key Orientate the supports with the step sitting on the mattress rails and on the inside of the bed. Now connect each support to the bed using the bolts. Connecting the rear safety panel You need: 4 x 3cm bolts, 4 x sleeve nuts, 4 x long bolts and 4 x barrel nuts Please use two people to complete this assembly... - Page 6 Fix the front safety panel 4 x 3cm bolts, 2 x sleeve nuts, 2 x long bolts and 2 x barrel nuts Choose the bed entrance (lEFT OR RIGHT) Lift the front safety panel onto the bed with the barrel nut holes (inside of bed) up against the bed leg opposite to the ladder entrance end.
- Page 7 Fit the mattress base (Lower bed) 34 wood screws (3cm) Note: Please use TWO people to prevent scratching your bed. Spread the mattress base out to full length on the mattress rails and screw every bed lath to the bed supports. Note: Please ensure that the bed lath fitted nearest to the bed end is positioned tight upto the bed end.
- Page 8 Fix the ladder hooks to the ladder You need: 4 x 2.5cm wood screws, 2 x ladder hooks and 2 x expanding bolts. Fit both ladder hooks to the ladder by screwing the hooks to the ladder using the pilot holes provided. Note orientation of the hook as shown Insert 2 x expanding bolts into the un-used leg holes at the bed entrance, tigthening both parts to ensure a secure fit.
- Page 9 Conversion Make two single beds (Convert the bunk) Two people required. Carefully remove the ladder, split the beds, remove the mattress bases and safety panels. Now switch one upper end with a lower end and tighten the bolts. Now fit the mattress bases to the beds.