Installing Part Feeding - Epson Part Feeding 7.0 IF-240 Manual

3.5.2 Installing Part Feeding

To ensure normal vibration behavior the Part Feeding must be correctly installed on a base
table specifically defined for the application. An incorrect installation of the Part Feeding
could compromise the performances of the product.
3.5.2.1 Position of Part Feeding to installing on the table and specification of
the table
The Part Feeding must be installed either on a rigid base table screwed to the ground or on
a not secured but heavy base table. For the second application the mass [M] and the
dimensions [A × B] of the base table must be large enough to absorb the vibrations generated
by the feeder.
3.5.2.2 Installing Part Feeding on the table
The Part Feeding must be properly installed on the base table.
NOTE ■ About number of screws and size of screws when installing on the base table,

refer to 3.5.5.2 Specification of Screw.
Part Feeding 7.0 IF-240 Rev.7
3. Environment and Installation
19