Table of Contents
Advertisement
Protouch2 GUI User Manual
In Offline mode, the Hub need not be connected to the system in which the tool is
running. Only configuration generation can be done in this mode. Programming
cannot be done in Offline Mode.
10 USB Hub Devices
10.1 Online Hub Configuration Page
MCHP hubs contain several registers that can change the behavior of the hub. It can
be changed to a new value through the PT2 application by programming the
configuration memory.
MCHP Hub configuration items are divided into the following three categories and
are available under 3 different tabs as shown below
Basic Features (Shown by default)
Advanced Features
Special Features
USB253X/USB(8)460X/USB3X13:
USB57X4:
2016 Microchip Technology Inc
Page 16
Advertisement
Table of Contents
Need help?
Do you have a question about the Protouch2 and is the answer not in the manual?