Assembly - Schwinn 190 Assembly Manual / Owner's Manual

1. Attach Leveler Feet to Rear Stabilizer and Attach Stabilizers to Main Assembly
Note: Hardware(*) is pre-installed on the Stabilizers and not on Hardware Card. Carefully remove packaging
material in Rear Stabilizer bracket and under the Top Shroud (5) and discard safely. Do not secure the Top
Shroud at this time. Align the center hole (2a) on the Rear Stabilizer with the pin in the Rear Stabilizer bracket.
The pin supports the bike during installation of the Rear Stabilizer hardware.
A
3
2
A
5
1
4
*
*
*
5 mm
Pin
2a
X4
*
*
*
2a
X6

ASSEMBLY

5 mm
2
9