Table of Contents
Advertisement
Always ensure that the unit is firmly fixed in order to avoid vibration and slipping during operation. The
structure that the unit is attached to must be secure and capable of supporting at least 10 times the
unit's weight. ALWAYS use safety cables that can support at least 12 times the weight of the unit when
installing the fixture.
This equipment must be installed by a professional, and it must be installed in a place where it is out of
the reach of the general public.
Ensure ALL connections and end caps are properly sealed with a non-conductive dielectric
grease (available at most electrical suppliers) in order to prevent water ingress/condensation
and/or corrosion.
This device is fully operational in three different mounting positions: hanging upside-down, mounted
sideways on trussing, or set on a flat level surface. Be sure this fixture is kept at least 12m (40ft) away
from any flammable materials (decoration etc.).
Screw one clamp into the Omega bracket using an M12 screw and nut. Insert the quick-lock fasteners
of the Omega bracket into the respective holes of the adjustable mounting bracket, then tighten the
quick-lock fasteners fully clockwise. Pull the safety-cable through the eyelet loop located on the rear
of the unit and over the trussing system or a safe fixation spot, then insert the end in the carabine and
tighten the safety screw. ALWAYS use and install a properly rated safety cable as a safety measure to
prevent accidental damage and/or injury in the event that the clamp fails.
INSTALLATION
CLAMP
OMEGA BRACKET
9
SAFETY CABLE
RIGGING POINT
Advertisement
Table of Contents
