Replas Premier Bench Assembly Instructions

1.8 m free standing, 3 supports

Premier Bench

Assembly Instructions:

IMPORTANT:

Please read carefully before assembling

1. Place bench slats face down on a ﬂat surface.

2. Using the 65 mm hex head screws supplied, screw

the support onto the slats, taking care not to over

tighten as this could strip the thread in the support.

3. Once all the screws have been tightened turn over the

bench and place it into position.

If you require further installation assistance, please contact your supplier.

1.8 m Free Standing, 3 Supports

Components List:

1 x Bench Top preassembled

2 X Bench Supports

12 X 14g x 75mm Hex Head Screws

www.replas.com.au

Table of Contents

Need help?

Do you have a question about the Premier Bench and is the answer not in the manual?

Page 1 Premier Bench 1.8 m Free Standing, 3 Supports Assembly Instructions: IMPORTANT: Please read carefully before assembling 1. Place bench slats face down on a ﬂat surface. 2. Using the 65 mm hex head screws supplied, screw the support onto the slats, taking care not to over tighten as this could strip the thread in the support.
Page 2 Premier Bench 1.8 m In Ground, 3 Supports Assembly Instructions: IMPORTANT: Please read carefully before assembling 1. Place bench slats face down on a ﬂat surface. 2. Using the 65 mm hex head screws supplied, screw the support onto the frame.