Table of Contents
Advertisement
The functions of the control panel
Options and functions for programmes
Programme
289
Programme
Use process
How to use the washer
Before washing clothes for the first time, you must run a complete cycle without clothes.
To do this:
1.Connect the power and turn on the tap.
2.Turn the knob to position "Standard".
3.Press "Start/Pause".
This will remove any water remaining in the tub from the manufacturers testing process.
Washing preparation
1. Connect the inlet hoses well and turn on the tap.
2. Ensure the power socket is grounded correctly, insert the power plug into the power socket.
3. Position the drain hose appropriately.
Preparation of clothes
1.
Sort the laundry by colour and by care label. Most garments have a
textile care label in the collar or side seam.
Ensure all pockets are empty. Foreign objects (e.g. nails, coins,
2.
paper clips, etc.) can cause damage to garments and components in
the machine.
3.
Close any zips and fasten hooks and eyes etc before washing.
4.
Dark textiles often contain excess dye and should be washed separately
several times before being included in a mixed load. Always wash whites
and coloureds separately.
5.
Badly soiled areas, stains etc. should be pre-treated with liquid detergent,
stain removers etc.
Wash clothes which pill easily inside out.
6.
Put clothes into the washer
Unfold the laundry and load loosely into the drum. Mixing both large and small items gives better
wash results and helps distribute the load evenly during spinning. The most efficient use of energy
and water is achieved when a full load is washed. However, do not overload as this causes creases
and reduces cleaning efficiency.
Make sure that no garments are caught between the
door and the seal.
Use process
Diagram 1
Diagram 2
Diagram 3
Advertisement
Table of Contents
