How To Use Washer - Galanz WMUK001W User Instruction Manual

How to use the washer
Before washing clothes for the first time, you must run a complete cycle without clothes.
To do this:
1.Connect the power and turn on the tap.
2.Turn the knob to position "Standard".
3.Press "Start/Pause".
This will remove any water remaining in the tub from the manufacturers testing process.
Washing preparation
1. Connect the inlet hoses well and turn on the tap.
2. Ensure the power socket is grounded correctly, insert the power plug into the power socket.
3. Position the drain hose appropriately.
Preparation of clothes
1. Sort the laundry by colour and by care label. Most garments have a
textile care label in the collar or side seam.
2. Ensure all pockets are empty. Foreign objects (e.g. nails, coins,
paper clips, etc.) can cause damage to garments and components in
the machine.
3. Close any zips and fasten hooks and eyes etc before washing.
4. Dark textiles often contain excess dye and should be washed separately
several times before being included in a mixed load. Always wash whites
and coloureds separately.
5.
Badly soiled areas, stains etc. should be pre-treated with liquid detergent,
stain removers etc.
6. Wash clothes which pill easily inside out.
Put clothes into the washer
Unfold the laundry and load loosely into the drum. Mixing both large and small items gives better
wash results and helps distribute the load evenly during spinning. The most efficient use of energy
and water is achieved when a full load is washed. However, do not overload as this causes creases
and reduces cleaning efficiency.
Make sure that no garments are caught between the
door and the seal.
How to use the washer
Use process
1. Open the drawer and add adequate detergent into the main wash compartment marked "
2. Add fabric softener into the compartment marked "
3. Add the detergent into the pre-wash compartment marked "
4. Close the drawer.
The right amount to dispenser will depend on the following:
Diagram 1
Diagram 2
1.Turn on the water tap, and connect the power.
2.Open the door, and load the clothes into the drum one by one.
Diagram 3
3.Close the door, and put suitable amount of detergent and fabric softener into the dispenser.
4.Choose the desired programme by turning the knob .
5.Press the "Temp" button and select a washing temperature.
6.Press " Start/Pause" button to start the washing machine.
7.When the cycle is finished, the warning tone sounds (If activated)
Using the detergent drawer
Do not exceed the maximum level mark.
you select.
The quantity of laundry
The soiling level of the laundry
- Lightly soiled
No visible dirt or stains. Possibly slight body odour.
- Normally soiled
Visibly dirty and/or just a few slight stains.
- Heavily soiled
Visible dirt and stains and/or dried on soiling.
The water hardness level.
It is recommended to use low foaming powder for all washing temperature programmes.
Washing steps
Close the drawer.
When the washing cycle is finished, the machine will change into standby mode.
If there is no further use for 10 minutes, the machine will automatically go into
sleep mode
Use process
"or " ".
" or " " .
" or " " according to the programme
Main wash compartment
Fabric softener compartment
Pre-wash compartment