Table of Contents
Advertisement
Available languages
Available languages
ENCLOSURES
The equipments are manufactured in the following versions: .......... Indoor version built in a bichromated steel enclosure at carbon,
OPTIONALS
Telemanagement pack.
GSM modem.
Lightning arrestors.
Manual bypass.
Timer / astronomical clock.
LCD panel.
Extended communications card.
7.2.- Glossary.
• Soft start
• Autotransformer
• Booster
• Terminal
• Bypass
• Control centre board
• Electromagnetic compatibility
• Contactor
with baseboard with four holes for fixing it to the floor where it
will be installed.
Outdoor version built in metallic cabinets of steel at carbon,
and cathephoresis treatment. Or in polyester cabinets.
Start up or switching type of the lights. It is done, in order to avoid both the
mechanica stress of the lamps have and the overload that it is done when they are
started up at nominal voltage.
Input transformer type in the equipment, which its feature is not to have galvanic
isolation.
Or compensator transformer, it is used to control the system through a sample of the
total input current.
Appropriate connector to connect a cable of important dimensions.
It is the system that connects the output with the input when there is a problem in
the loads or equipment. It avoids the light shutdown.
Electrical board destined to supply, distribute, protect, etc., the light installations.
Its target, is to establish the evaluation procedures for the conformity and protection
requirements regarding to the electromagnetic compatibilty of the equipments, sys-
tems and installations for its later commercialising and start up.
The contactor is used to connect the power parts and it will allow to make automatic
the maneuvers. Basically it is a three phase switch that it is turned on remotely, with
minimum physical effort and high safety through a coil.
- 28 -
Advertisement
Table of Contents
