Salicru ILUEST NE Series User And Operating Manual page 15

3.4.2.- Manual Bypass.
Optionally the ILUEST is supplied with a manual Bypass switch of two positions, that allows selecting the output voltage either
directly from the mains (position 1), or from the ILUEST (position 2).
If the ILUEST has this optional included, it is added its respective «User's manual EK203*». Read it, for its correct utilization.
3.4.3.- Timer.
When the ILUEST is requested with this optional, the settings of itself will be done according to the attached sheet of the timer.
3.4.4.- Astronomical clock.
When the ILUEST is requested with this optional, the settings of itself will be done according to the attached sheet of the
astronomical clock.
3.4.5.- LCD display.
With the purpose of endowing the equipment with a practical and powerful display, optionally there is a LCD panel. Read the
specific manual of itself (EK437*05).
3.4.6.- Telemanagement pack.
With the purpose of endowing the equipment with remote communications, optionally the Telemanagement pack can be
installed, it consists in an electronic PCB which is placed in the ILUEST and allows local and/or remote communication of the
equipment with a control centre. For its right operation read the specific manual of itself (EK381*00).
3.4.7.- GSM modem.
In case the ILUEST is requested with Telemanagement pack, it is possible to acquire the GSM modem for its remote commu-
nication with the control centre. Read carefully the manufacturer instructions attached with itself.
3.4.8.- Lightning arrestor.
In those installations that it is required (important voltage fluctuations at the input due to frequent lightnings), it is possible its
installation at the input of the equipment.
3.4.9.- Extended communication card.
This card will allow the ILUEST to accept analogical signals (0-20mA, +5V -5V, etc.) from programmable logic controllers (PLC),
lighting sensors, etc. and will provide some saving levels.
- 15 -