Page 1
Technical Specification Trouble Shooting Important information The SPARTAN MP series of explosion protected floodlights/highbay are specialist devices, certified for use in specific operating environments. The units must be installed in accordance with these instructions, must be correctly certified for the specific operating environment and must be installed by suitably qualified personnel.
3. If the SPARTAN unit is to be installed in areas of high vibration, please consult with Raytec. 4. Externally the SPARTAN unit housing is constructed from marine grade aluminium, and toughened glass, stainless steel brackets/fasteners and silicone gaskets, internally there are many non metallic components.
2. Installation Mounting SPARTAN Unit 1. To meet the requirements of certification a MINIMUM of 2 fixing points must be used, the fixing points must be suitable for the conditions of use. 2. The line diagrams below are for guidance only – units may be mounted in any orientation Mounting MP SPARTAN Unit –...
Page 4
Mounting SPARTAN Unit – Highbay Application www.raytecled.com UK / Europe Tel: +44 (0) 1670 520055 Americas Tel: +1 613 270 9990...
Page 5
Typical wiring diagram WIRING Z1 & Z2 LIGHT ENGINE J1 +ve J2 -ve PSU / TERMINAL BOX RETENTION CORD N E L1 L2 MAINS INPUT 110-277V AC Wire the Mains cable into the terminal block. Provision has been made for this and identified as the E (Earth), L1 (Switched Live), L2 (permanent live) and N (Neutral) terminals.
3. Maintenance It is essential that all SPARTAN units are maintained in accordance with the requirements of the EN60079-17 standard: (Electrical apparatus for explosive gas atmospheres – other than mines). IMPORTANT. No modifications are permitted to the unit, all spare parts must be purchased from the manufacturer, unauthorized modifications or spare parts will invalidate certification and make the equipment dangerous.
4. Technical Specification 60W version 120W version Input Voltage 110-277V AC Input Current (230Vac, full load) 0.26A 0.52A Consumption 120W Power Factor (230Vac, full load) >0.97 Mains Frequency 50/60Hz Inrush Current (I @50%) 53A, ∆t < 300µs peak Total Harmonic Distortion (230Vac, full load) ≤10% IP Rating IP66/67...
Page 8
With The Atex Directive 2014/34/EU & UK Directive SI 2016 No. 1107 (as amended) Raytec Ltd. declares under our sole responsibility that the product(s) listed below conform with the relevant provisions of directive 2014/34/EU of 20 April 2016 and UK Directive SI 2016 No. 1107 (as amended)
Page 9
Compliance with the Essential Health and Safety Requirements has been assessed by reference to the following harmonised/designated standards - EN 60079-0 : 2018 EN60079-7 : 2015 + A1 2018 EN 60079-18 : 2015 + A1 2017 EN60079-31 : 2014 And also 2014/35/EU - Low Voltage Directive, 2014/30/EU - EMC Directive Signed Name Barry Thompson...
Page 10
Tel: +44 (0) 1670 520055 Tel: +1 613 270 9990 sales@raytecled.com sales@raytecled.com Raytec Ltd. Raytec Systems Inc. Unit 15 Wansbeck Business Park, Rotary Parkway 800-300 Terry Fox Drive, Ottawa, Ontario Ashington, Northumberland, NE63 8QW, United Kingdom 2K 0E3, Canada raytecled.com...