Table of Contents
Advertisement
Maintenance
Periodic Maintenance
Check Blower
Housing/Impeller
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Inspect for wear or damage daily. Replace or
repair worn parts as needed.
Note: When mowing in areas with sandy soil,
use low lift blades on the cutting deck and higher
cutting heights to minimize wear on the blower
components.
Check Bags
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Inspect the bags for wear, tears, or damage.
WARNING
Under normal use the bag will deteriorate and
wear. Objects could exit through worn bag
at high speeds. Thrown objects can cause
serious injury or kill you or bystanders.
Check bags frequently for tears and holes.
Replace worn bags only with Exmark
replacement bags.
Lubricate Grease Fittings
Note: See chart for service intervals.
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Lubricate fittings with NLGI grade #2
multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
Lubrication Chart
Fitting
Initial
Locations
Pumps
1. Idler
1–2
Bushings
Number of
Service
Places
Interval
1
25 Hours
Check Condition of Belt
Service Interval: Every 50 hours
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Inspect the belt for damage or wear. Replace belt
with one of the following:
Deck
60 inch
72 inch
18
Part No.
103-0866
103-0867
Advertisement
Table of Contents
