Table of Contents
Advertisement
Maintenance
Periodic Maintenance
Check Blower
Housing/Impeller
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Inspect for wear or damage daily. Replace or
repair worn parts as needed.
Note: When mowing in areas with sandy soil,
use low lift blades on the cutting deck and higher
cutting heights to minimize wear on the blower
components.
Check Bags
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Inspect the bags for wear, tears, or damage.
WARNING
Under normal use the bag will deteriorate and
wear. Objects could exit through worn bag
at high speeds. Thrown objects can cause
serious injury or kill you or bystanders.
Check bags frequently for tears and holes.
Replace worn bags only with Exmark
replacement bags.
Check Condition of Belt
Service Interval: Every 50 hours
All Units
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Inspect the belt for damage or wear. Replace belt
with one of the following:
Deck
44 inch
48 inch
52 inch
60 inch
Part No.
119-1566
116-4844
1-653333
703636
Cleaning
Clean Muffler and Rear
Frame Area
Service Interval: Before each use or daily
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
WARNING
Operating engine parts, especially the muffler,
become extremely hot. Severe burns can occur
on contact and debris, such as leaves, grass,
brush, etc. can catch fire.
• Allow engine parts, especially the muffler, to
cool before touching.
• Remove accumulated debris from muffler and
engine area.
Clean Rear Screen In Hopper
Service Interval: Before each use or daily
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Open hopper and remove clippings that are stuck
to the screen.
Clean Blower
Service Interval: Yearly or before storage
Grass build up may cause problems with the impeller
when the unit is put back into operation.
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Remove grass buildup from around the impeller
before placing it in storage.
18
Advertisement
Table of Contents
