Maintenance; Recommended Maintenance Schedule(S); Periodic Maintenance; Inspect Standon - Exmark STANDON Operator's Manual

Maintenance

Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
WARNING
While maintenance or adjustments are being
made, someone could start the engine.
Accidental starting of the engine could seriously
injure you or other bystanders.
Remove the key from the ignition switch, engage
parking brake, and pull the wire(s) off the spark
plug(s) before you do any maintenance to the
unit or StandOn. Also push the wire(s) aside so it
does not accidentally contact the spark plug(s).

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
Before each use or daily
Yearly

Periodic Maintenance

Inspect StandOn

Service Interval: Before each use or daily
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Inspect for loose hardware. Tighten any loose
hardware.
3. Inspect for wear or damage daily. Replace or
repair worn parts as needed before operating.

Check StandOn for Buildup

Service Interval: Before each use or daily
Check for dirt/mud buildup between tire and fender.
Remove buildup before operating.

Lubricate Grease Fittings

Note: See chart for service intervals.
Maintenance Procedure
• Inspect the StandOn.
• Check for dirt/mud buildup between tire and fender.
• Grease caster wheel hub.
• Lubricate the caster wheel hubs.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Lubricate fittings with NGLI grade #2
multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
Lubrication Chart
Fitting Initial
Locations Pumps
1. Caster 0
Wheel Hub

Lubricate Caster Wheel Hubs

Service Interval: Yearly
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
12
Number of Service
Places Interval
1
Yearly