NewAir NKR058MB00 Owner's Manual page 15

Guardrail Installation
•
Take the guardrail and place its feet into the pilot holes in the top of the
cabinet.
•
Screw the railing into place using the screws provided.
CO2 Regulator Installation
The purpose of the CO2 regulator is to allow you to control the gas flowing
from the cylinder into the keg. Here is how to install it:
1. Attach the CO2 regulator to the cylinder by turning the regulator nut onto
cylinder valve, making sure a washer is securely inserted before connecting
the nut.
2. Tighten the CO2 Inlet nut using an adjustable wrench (not supplied) to
assure there are no leaks.
3. Once you are ready to tap your keg (see page 18 ), open the pressure
adjustment knob.
4. The pressure gauge monitors low internal keg pressure and should be
adjusted to 10-12 PSI.
Note: If the PSI reaches higher than 12, use the pressure release valve to lower
excess CO2 being held in the regulator.
www.newair.com
EN
15