Assembly & Installation - NewAir NKR058MB00 Owner's Manual

ASSEMBLY & INSTALLATION
INSTALLATION INSTRUCTIONS
BEFORE USE:
• Remove the exterior and interior packaging.
• Before connecting the unit to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• This appliance is designed for free standing installation.
• Place the unit on a flat, solid floor that is strong enough to support it when it
is fully loaded. To level the appliance, adjust the front leveling leg at the
bottom of the unit.
• When moving your kegerator, please do not incline it more than 45 degrees.
• Locate the appliance away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption.
• The kegerator should be placed in an area where the ambient temperature is
less than 90 degrees Fahrenheit and higher than the lowest temperature you
want to store your kegs at. If the ambient temperature is lower than the set
temperature, the internal temperature will match the ambient temperature.
• Avoid locating the unit in damp areas.
• Plug the kegerator into an exclusive, properly installed and grounded wall
outlet. Do not under any circumstances cut or remove the third (ground)
prong from the power cord. Any questions concerning power and/or
electrical grounding should be directed to a certified electrician or
authorized products service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down
for 3 to 4 hours before placing a keg or any other items in the appliance.
www.newair.com
EN
10