NewAir NKR058MB00 Owner's Manual page 11

CHANGING DOOR SWING DIRECTION
Step 1: Lay the unit on its back.
Step 2: Remove the kickplate by removing the three retaining screws (FIG. 1).
Step 3: Remove the four screws located on the lower door hinge (FIG. 2).
Step 4: Pull the door downward until it releases from the upper hinge pin.
Step 5: Remove the plastic screw cap from the top left-hand side (FIG. 3) and
install it on the top right-hand side of the door frame.
Step 6: Unscrew the upper door hinge pin (FIG. 4) from the right side of the
countertop and install it on the left side of the countertop.
Step 7: Position the door back on the cabinet and push up until the top hinge
pin is inserted into the top of the door.
Step 8: Remove the lower support pin from the door and reposition it on the
lower hinge (FIG. 5).
Step 9: Re-install the lower support pin on the right side of the door.
Step 10: Make sure to align the door and cabinet before fastening the lower
hinge screws to the cabinet.
Step 11: Re-install the kick-plate.
www.newair.com
EN
11