Table of Contents
Advertisement
7.17.6
E.M.C. Compliance - Installation Requirements
The HEGS5300 keyboard, supplied, includes a one meter standard length of interface
cable. Should there be a need, for a longer cable, an extension kit is available from the
supplier.
This kit has two Amidon Associates FB-43-6301 Shielding Beads and interconnect cable
(Beldon 8723 or equivalent) cut to the required length.
As the HEGS5300 is supplied as an O.E.M. component, there is therefore a mandatory
requirement, to specify the installation parameters, in order to comply with the European
Directives on E.M.C.
The HEGS5300 keyboard has been installed, tested and found to comply under the
following conditions:
1. With the standard lead attached to the System Controller.
2. With the standard lead attached to an approved telecommunications modem and
with the power requirements supplied by a CE approved Plug Pack.
3. With the standard lead attached to an Optic Fiber Transmitter and with the power
requirements supplied by a CE approved Plug Pack.
4. With a passive extension (not exceeding 50m total) using the cable and Shield
Beads, defined above, and with the Shield Beads fitted adjacent to the connectors.
Rev. C
WARNING: It should be noted that any variation to the
above conditions may not comply with the European
Directives on E.M.C. and therefore must be cleared with
the supplier before implementation.
7.17-7
HMXMU001018
10/06
Advertisement
Table of Contents
