Honeywell MAXPRO-Net Hardware Installation Manual page 94

7.11.4 Motor Drive, Continued
LED Indicators
The motor, brake and lens outputs each have a pair of LEDs to indicate when the output
is driving either +ve or –ve. These are listed below.
SW3 Switch Settings
The use of the motor drive switch SW3 is summarized in the table below. Following is a
more detailed description of the use of each switch.
SW3
1
2
3
4
5
6
7
8
SW3-1 Lens Voltage
This switch sets the voltage required to control zoom, focus and manual iris on the
camera lens.
SW3-2 Privacy Zones
Privacy Zones. When switched on privacy zones are enabled.
Rev. C
LED INDICATION
L6 Focus –ve
L7 Focus +ve
L8 Zoom –ve
L9 Zoom +ve
L10 Tilt –ve
L11 Tilt +ve
L12 Tilt Brake –ve
L13 Tilt Brake +ve
L14 Pan –ve
L15 Pan +ve
L16 Pan Brake –ve
L17 Pan Brake +ve
DESCRIPTION
Lens Voltage
Privacy Zones
Auto Home
Pan/Tilt inversion
Focus/Zoom inversion
I/O fitted
Speed 1
Speed 2
7.11-6
ON OFF
6 Volt 12 Volt
Enabled Disabled
Enabled Disabled
Inverted Normal
Inverted Normal
Enabled Disabled
Ref to table
Ref to table
FACTORY
ON
OFF
OFF
ON
OFF
OFF
HMXMU001018
10/06