Table of Contents
Advertisement
7.11.4
Motor Drive, Continued
SW3-3 Auto Home
If this option is enabled, the PTZ will return to the preset position of view 0 after one
minute of no operation. Note that View 0 must be set before this function can operate.
SW3-4 Pan/Tilt Inversion
Allows the camera to be invert-mounted on the pan/tilt unit. Setting this switch ON will
reverse pan left/right and tilt up/down outputs from the RD-378, so that the camera can
be invert mounted, yet maintaining the wiring connections as per connection data.
SW3-5 Focus/Zoom Inversion
Manufacturers of lenses vary the use of +ve or –ve for in/out lens functions. This switch
is set to ensure the button function on the keyboard matches the actual operation
performed. This must be set correctly for the pan/tilt dynamic speed control from zoom
position to operate.
SW3-6 I/O Fitted
If the optional IO-378 board is fitted, then this switch must be switched ON. This allows
for seven additional alarm inputs and eight voltage free contact control outputs to
operate at the site as well as manual iris control.
SW3-7 and SW3-8 Speed Control
These switches are set depending on the type of pan/tilt unit being used. Their use is
described in the following table.
DESCRIPTION
STANDARD DC PTZ (Less than 40° /sec)
Full variable speed from analogue joystick, and auto two
speed (medium/fastest) from normal joystick. Graded pan/tilt
speed depending on lens zoom.
STANDARD DC PTZ (Less than 40° /sec)
Full variable speed from analogue joystick, and auto two
speed (medium/fastest) from normal joystick. Graded P/T
speed depending on zoom in position. Additional
Step/pause/run allows small increments of manual position
placement.
HIGH SPEED DC PTZ (Greater than 40° /sec, i.e. Fast
domes)
Full variable speed from analogue joystick, and auto two
speed (slowest/medium) from normal joystick. Graded
pan/tilt speed depending on lens zoom. Includes fine position
incremental placement of view calls.
HIGH SPEED DC PTZ (Greater than 40° /sec i.e. Fast domes)
Full variable speed from analogue joystick, and auto two
speed (slowest/medium) from normal joystick. Graded P/T
speed depending on zoom in position. Includes fine position
incremental placement of view calls and Step/pause/run for
small increments of manual position placement.
Rev. C
7.11-7
SW3-7
SW3-8
OFF
OFF
ON
OFF
OFF
ON
ON
ON
HMXMU001018
10/06
Advertisement
Table of Contents
