Learn Mode - Honeywell MAXPRO-Net Hardware Installation Manual

7.15.9 Description of Control Functions, Continued.
FUNCTIO ALL IR-PPM
N VCR
NUMBER DEVICES
22 (unavailable)
23 (unavailable)
24 (unavailable)
25 (unavailable)
26 (unavailable)
27 (unavailable)
28 (unavailable)
29 (unavailable)
30 (unavailable)
31 (unavailable)
32 (unavailable)
CAUTION: IR-PPM devices are limited to only 16 control functions (1 to
16). RS-232 devices support a maximum of 32 control functions.
7.15.10 I.R. Learn Mode
The RD490 module has the capability to "learn" IR control sequences. This is of
particular value should the control be required for a device for which no generic device
mode exists or where functions other than those which are pre-programmed in the
generic modes are required.
I.R. Learn Mode Procedure
1. Select learn mode on Dip Switch 2 (6, 8 on; 5, 7 off).
2. Plug in the card, after reset press the learn button (at the top front edge of the PCB
board. Note that LED's 1, 3, 5, 7 will flash.
3. Direct the IR remote control towards the IR sensor at a distance of approximately
35mm (approx. 1"). Press any key and then release, LED's 2, 4, 6, 8 will now flash.
4. Press the remote control key again and release (after about 0.5sec). Note LED 1 will
now flash.
Rev. C
RS-232
PANASONIC VCR
Time-lapse Time-lapse (120h) mode
(120h) mode
Time-lapse Time-lapse (168h) mode
(180h) mode
Time-lapse Time-lapse (240h) mode
(240h) mode
Time-lapse Time-lapse (480h) mode
(480h) mode
Alarm Active (unavailable)
Alarm clear (unavailable)
(unavailable) (unavailable)
(unavailable) (unavailable)
(unavailable) (unavailable)
(unavailable) (unavailable)
Set Time Set Time (3:00am)
(3:00am)
7.15-9
RS-232
MITSUBISHI VCR
DEDICATED
MICROS
MULTIPLEXER RS-
232
Activity key
Encode key
Decode key
VCR key
Sequence key
Hold (freeze) key
Up-arrow key
Down-arrow key
Left-arrow key
Right-arrow key
Set Time (3:00am)
HMXMU001018
10/06