Toyota BT lifter LHM075H Operator's Manual page 132

5 Working with the truck
It is not permitted to use the truck for purposes other than those for which it
has been designed and manufactured. Using the truck for the following ap-
plications is therefore not permitted:
loading and unloading trucks/lorries
▷
Truck area
The truck may be used only on a firm and even surface, such as concrete or
asphalt.
It is not permitted to drive the truck on uneven surfaces or across obstacles.
These cases may damage parts of the truck, and the truck may stop working.
Handling loads
Only handle loads that are within the truck's permitted lifting capacity.
Always drive the truck with the load at the back. It is not permitted to
▷
transport loads in the other travel direction.
Reduce the lifting height of the load when transporting. The load must al-
▷
ways be as close as possible to the surface.
5.4.3 LHM230WI user manual
The instructions below is an addendum to other information in the manual,
and apply specifically to this truck.
Introduction
The weight indicator is used to estimate the weight of the goods placed on
the truck forks. It shows weights up to 2300 kg in steps of 5 kg. The precision
is 0-200 kg ±10 kg, 201-1000 kg ±20 kg, >1000 kg ±50 kg. The indicator con-
tains electronic parts, and should not be exposed to extremes of humidity or
temperature differences.
The best weighing results are obtained if the load is evenly distributed on the
forks.
Symbols
Symbol
132
Description
Resetting
Confirms or moves the cursor to the left during calibra-
tion.