Table of Contents
Advertisement
6 – Various Playback Functions
the display.
2 Press the PITCH [MENU] knob on the player or the
REPEAT button on the remote at the beginning of
the interval that you want to repeat (A point).
will blink at the top of the display.
3 Once again, press the PITCH [MENU] knob on the
player or the REPEAT button on the remote at
the end of the interval that you want to repeat (B
point).
Repeat playback between the A and B points will
begin, and
will stop blinking and continue to
A-B
appear at the top of the display.
4 To end A-B repeat playback, press the ª (stop)
[INTRO CHECK] button on the player or the ª STOP
button on the remote.
NOTE
A-B repeat playback cannot be used with a data CD.
•
Once playback reaches the B point, playback will restart
•
from the A point.
A-B repeat playback across more than one track is not
•
possible.
Intro check mode
The Intro Check mode allows 10-second track beginnings
to be played in succession. Use the following procedures
to enable this mode.
Using the front panel buttons:
1 When stopped and in shift mode (SHIFT indicator
lit), press the ª (stop) [INTRO CHECK] button.
appears on the right side of the display.
2 Disable shift mode (SHIFT indicator not lit) and
press the Á (play) [REPEAT] button to activate the
intro check mode starting from the next track.
3 Press the ª (stop) [INTRO CHECK] button again to
stop the play and disable intro check mode.
Using the remote control:
1 When stopped or paused, press the remote INTRO
CHECK button to enable intro check mode.
appears on the right side of the display.
26
TASCAM CD-500/500B
A-B
INT
Appears
F
M
S
INT
Appears
M
S
F
NOTE
If you press the INTRO CHECK button on the
remote control during playback,
the right side of the display and intro check starts
immediately.
2 If stopped or paused, press the Á PLAY button to
start intro check.
3 Press the ª STOP button to stop playback and
disable intro check mode.
Press the INTRO CHECK button again to disable
intro check mode and continue playback.
Power on play function
By using a commercially-available external timer, you
can make the player turn on at desired times and start
playback.
1 First, connect the power of this unit so that it
receives power from the timer.
2 Load the disc that you want played back.
3 Set the
menu item to
07 P onPL
value:
).
OFF
4 Leave the POWER switch of this unit set to ON, turn
the power off from the timer and set the timer to
turn on at the desired time. At the set time, the
timer should supply power to the player, turning it
on, and playback should begin automatically.
NOTE
The power on play function on/off setting is retained even
when the power is turned off.
Pitch control playback
Using its pitch control playback function, this unit can
vary the pitch (and speed) of playback.
Follow these procedures to use pitch control playback.
When this function is on,
PITCH
appear in the PITCH display area on the right side of the
display.
Using the front panel buttons:
Press the PITCH [MENU] knob to turn the pitch control
function on. Turn the PITCH [MENU] knob to adjust the
setting in the range between −16% and +16%.
appears on
INT
(default
ON
and the setting value
Current value
M
S
F
Advertisement
Table of Contents
