Table of Contents
Advertisement
7 – Other Functions
User data settings (CD-500B only)
You can set whether or not a USER DATA BIT is output
with the digital output from the DIGITAL OUT (AES/EBU)
connector. To set output of the USER DATA BIT, use the
menu item (default value:
U-DATA
NOTE
If the signal output from this connector does not play
•
back correctly, set this item to
The user data setting is retained even when the power
•
is turned off.
Using the parallel control
(CD-500B only)
Using the CONTROL I/O PARALLEL connector, you can
use external parallel control to operate this unit. Two
types of parallel control (normal mode and direct play
mode) can be used with this unit. To set parallel control,
use the
menu item.
23 PARALL
Options:
Normal mode (default)
1
In addition to starting, stopping and skipping, fader
start/stop are controlled.
Direct play mode
2
Tracks 1–20 can be played directly.
The pin assignments are as follows
CONTROL I/O
PARALLEL
8
15
Function
Pin
No.
MODE: 1
←
1
STOP Tally
SKIP （ Back）
2
Select: 1
SKIP （ Forward）
3
Select: 2
←
4
NO DISC Tally
←
5
EOM
SEARCH （Back）
6
Track Play: 1*
SEARCH （Forward）
7
Track Play: 2*
←
8
GND
34
TASCAM CD-500/500B
22
).
ON
.
OFF
1
9
IN/OUT
MODE: 2
OUT
IN
IN
OUT
OUT
IN
IN
←
9
PLAY Tally
10 PAUSE Tally
FLASH LOAD Tally***
11 FADER START／STOP
Track Play: 3*
12 STOP
STOP／FLASH LOAD**
13 PLAY
Track Play: 4*
14 PAUSE
Track Play: 5*
←
15 +5V
IN: active low external command reception (operates
when ground 30 ms or longer)
OUT: signal for the display of transport status by open
collector (maximum voltage 15 V, maximum current 50
mA)
+5V: maximum supplied current 50 mA
* Track Play 1–5: plays the designated track. The track
played depends on the combination of Select: 1 (Pin
2) and Select: 2 (Pin 3) High (1) and Low (0) settings as
shown below.
** When stopped and the flash start function is on, if the
track beginnings have not yet been loaded, loading
starts. When playing back, playback stops.
*** When the flash start function is on, if the track
beginnings have been loaded completely, High (1)
results. If the track beginnings have not yet been loaded,
or are in the process of loading, Low (0) results.
Pin
Mode 2
Select 1 and 2 combination
function
No.
2
Select: 1
0
3
Select: 2
0
6
Track Play: 1
Track 1
7
Track Play: 2
Track 2
11 Track Play: 3
Track 3
13 Track Play: 4
Track 4
14 Track Play: 5
Track 5
NOTE
The parallel mode setting is retained even when the
power is turned off.
OUT
OUT
IN
IN
IN
IN
0
1
1
1
0
1
Track 6
Track 11
Track 16
Track 7
Track 12
Track 17
Track 8
Track 13
Track 18
Track 9
Track 14
Track 19
Track 10
Track 15
Track 20
Advertisement
Table of Contents
