Travis Industries 94700881 Quick Start Manual

Xtreme 6020 birch log set

The logs are made of a ceramic material that is FRAGILE. Carefully handle each log with both hands.

Overview

This log set is for use with an Xtreme 6020 that has been pre-configured for use with logs. The threaded stud

plates are pre-installed to suit these instructions.

(2) #1 Logs

(3) #2 Logs

(2) #3 Logs

(3) #4 Logs

(3) #5 Logs

The logs are arranged in the pattern shown below.

NOTE: The logs should be installed after the fireplace has been installed and tested for proper operation and

before installing the crushed glass.

NOTE: Remove the ¼" hex bolts on the end of each log. These bolts protect the threads during manufacture.

1. Each log has an identification # marked on the bottom (see photo below). Note the press nut on the

bottom of the log. This nut threads over the threaded studs on the stud plates.

Page 1 of 2

Xtreme 6020 Birch Log Set

(sku 94700881)

17601612 - Printed 5/3/10

Table of Contents

Do you have a question about the 94700881 and is the answer not in the manual?

Page 1 1. Each log has an identification # marked on the bottom (see photo below). Note the press nut on the bottom of the log. This nut threads over the threaded studs on the stud plates. Page 1 of 2 17601612 - Printed 5/3/10 © Travis Industries, Inc.
Page 2 Remove the glass and carefully inspect the areas above the burner for soot accumulation. If any soot is detected, re-adjust the log and repeat this step to insure no sooting occurs. Page 2 of 2 17601612 - Printed 5/3/10 © Travis Industries, Inc.