Table of Contents
Advertisement
Quick Links
The logs are made of a ceramic material that is FRAGILE. Carefully handle each log with both hands.
Overview
This log set is for use with an Xtreme 6020 that has been pre-configured for use with the driftwood log set. The
four (4) threaded stud plates are pre-installed to suit these instructions.
Packing List
•
Rear Left Log
•
Rear Right Log
•
Front Left Log
•
Front Right Log
Log Installation
NOTE: The logs should be installed after the fireplace has been installed and tested for proper operation.
NOTE: The log set affects airflow inside the fireplace. Adjust the air shutters to fully open position prior to
placing the glass. After operating the fireplace to insure proper flame performance, the air shutters may
be closed slightly if needed.
1. Make sure the stud plates for the driftwood logs are installed. Install the crushed glass media over the
perforated steel (see photo below). Make sure the crushed glass covers the stud plates but does not
cover the pilot (see manual for complete details).
Page 1 of 5
Xtreme 6020 Driftwood Log Set
(sku 94700882)
•
•
•
•
17601613 - Printed 5/13/10
Right Side Branch
Left Twig
Right Twig
Center Twig
© Travis Industries, Inc.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Travis Industries 94700882
Summary of Contents for Travis Industries 94700882
- Page 1 1. Make sure the stud plates for the driftwood logs are installed. Install the crushed glass media over the perforated steel (see photo below). Make sure the crushed glass covers the stud plates but does not cover the pilot (see manual for complete details). Page 1 of 5 17601613 - Printed 5/13/10 © Travis Industries, Inc.
- Page 2 3. The rear right log has two holes on the base that insert over the studs at the back of the firebox (see photos below). Slide it to the left so it contacts the rear left log and the back wall of the firebox. Page 2 of 5 17601613 - Printed 5/13/10 © Travis Industries, Inc.
- Page 3 5. The front right log has a hole on the base that fits over the last pin on the firebox floor. Position the log as shown below with the front of the log resting on the ledge near the glass frame with approximately 2” gap to the glass opening. Page 3 of 5 17601613 - Printed 5/13/10 © Travis Industries, Inc.
- Page 4 7. Position the left twig as shown below. Note how the twig rests on the front left log. Page 4 of 5 17601613 - Printed 5/13/10 © Travis Industries, Inc.
- Page 5 Remove the glass and carefully inspect the areas above the burner for soot accumulation. If any soot is detected, re-adjust the log and repeat this step to insure no sooting occurs. Page 5 of 5 17601613 - Printed 5/13/10 © Travis Industries, Inc.
Need help?
Do you have a question about the 94700882 and is the answer not in the manual?
Questions and answers