Codec C90
Contents
Introduction
xCommand HttpFeedback Deregister
Command used to deregister XML eedback over HTTP(S).
Required parameters with (r):
FeedbackSlot: <1..3>
Example:
xCommand HttpFeedback Deregister FeedbackSlot:1
OK
*r FeedbackDeregisterResult (status=OK):
FeedbackSlot: 1
*r/end
D14128.02—NOVEMBER 2008
Getting Started
Interfaces
About the API
xCommand
xConfiguration
xCommand
xStatus
The Key commands
xCommand Key Click
Command used to emulate pressing a key on the remote control for a short while. This command needs no
release command.
Required parameters with (r):
Key(r): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/
Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/
Square/SrcAux/SrcCamera/SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/
VolumeUp/ZoomIn/ZoomOut>
Duration: <0..65534>
Example:
To be described.
xCommand Key Press
Command used to emulate pressing a key on the remote control without releasing it. The Key Press
command should be followed by a Key Release command to emulate releasing the key.
Required parameters with (r):
Key(r): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/
Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/
Square/SrcAux/SrcCamera/SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/
VolumeUp/ZoomIn/ZoomOut>
Example:
xCommand Key Click Key:Home
*r KeyClickResult (status=OK):
*r/end
OK
System Integrator Guide
Cameras
Appendices
Contact us
75