Codec C90
Getting Started
Contents
Introduction
1
Turn on the system
•
Turn on the codec and wait a few minutes for the system to start
•
Make sure the remote control has the batteries installed.
•
Press
Home (
) on the remote control to show the menu on screen
•
When you can see the menu on screen, proceed to Step 2.
Show the menu:
•
Press
Home (
) on the remote control to show the menu on screen
Navigate in the menu:
•
Use the arrow keys on the remote control to navigate up and down in
the menus
Confirm your choice:
•
To confirm your choice, press
2
Verify IP address settings
Go to System Information to verify the IP address:
1.
Navigate to Settings > System Information
2.
When the IP address is automatically assigned from a DHCP server, the
Address of the codec is shown on the System Information page.
3.
Press
Home (
) to exit.
D14128.02—NOVEMBER 2008
Getting Started
Interfaces
About the API
OK (
) on the remote control
xConfiguration
xCommand
3
If you need to set a static IP address
Go to IP Settings to set static IP addresses:
1.
Navigate to Settings > Administrator Settings > IP Settings.
2.
Set IP Assignment to Static. Press the left arrow key to go back one step
3.
Enter the IP Address, Subnet Mask and Gateway address in the address fields.
The sequence is shown below.
4.
Press
OK to save the changes, or Cancel to leave without saving.
5.
Press
Home (
) to exit.
System Integrator Guide
xStatus
Cameras
Appendices
Contact us
12