Quick Arm; Quick Exit; Keypad Zones - DSC MAXSYS PC4020CF System Manual

Quick Arm

[ ]+[0]
Entering [ ] [0] is accepted as a valid arming code when
the "Quick Arm" feature is activated. This command is
often used when individuals are required to arm the
system but not disarm it. This could be used with home
visitors in the case of a residential alarm or junior
employees and maintenance staff in the case of a
commercial alarm. See instructions in the "[ ] [6] User
Functions Command" section for activating the "Quick
Arm" feature.

Quick Exit

[ ]+[0] When Armed
Entering [ ] [0] when the system is fully armed will allow
the user 2 minutes to exit the premises through any delay
zone without altering the status of the system if the "Quick
Exit" feature is enabled. After [ ] [0] is entered into an
armed system, one and only one delay loop may be
tripped. Any additional activity on any other active loop
will cause that loop to begin its alarm sequence. Quick
exit activation will be logged onto the event buffer.

Keypad Zones

There are three zones which can be activated from the
keypad. The alarm and restoral codes for keypad zones
are programmed using the [ ] [8] command.
Pressing the [F] key for 2 seconds activates a fire alarm.
The fire alarm sounds the siren/bell in a pulsed fashion.
Pressing the [A] key for 2 seconds activates a silent
auxiliary keypad zone.
Pressing the [P] key for 2 seconds activates a silent panic
keypad zone.
Programming for the [F], [A], and [P] keys for the global
keypad can be found under the System Toggle Options.
The global keypad will always send (if programmed) the
system area account code. The [F], [A], and [P] keys will
activate for all active partitions, any valid access code
from any partition may silence the alarm.
Note: See 'KEYPAD TOG OPT' in the Programming
Guide for changing keypad zones options.
Loss of COMBUS Communication
Supervision
If COMBUS communication to a module is lost for more
then 30 seconds, the LCD4520 will display the message,
SYSTEM TROUBLE
COMBUS ERROR
and the keypad buzzer will activate. The error message
will be cleared when data communication is restored to
the module.
24
firealarmresources.com