Table of Contents
Advertisement
Operation
Louver
Please open the louver by hand before operation.
(As the louver is hand-operated, it will not close
automatically at operation end.)
When you want to let the unit decide the best operation mode
Fill the water tank with water.
Attention
• Make sure that the humidifying filter unit is attached when performing this operation.
• Change the water in the humidifying tray and water tank every day.
• Be sure to use tap water for the water in the water tank.
Press
.
• Optimum operation will be performed according to the condition of the room.
• The AUTO operation lamp (white) lights up.
• If
is pressed during AUTO operation, the lamp corresponding to the current operation mode will blink for about
5 seconds.
Operation mode
Air Purifying Operation
Humidifying Operation
Monitoring mode
About AUTO operation
The unit automatically switches between Air Purifying
Operation and Humidifying Operation based on the
indoor temperature and humidity conditions.
• The airflow rate is adjusted automatically. If the
operating sound bothers you, the airflow rate range can
►Page 21, 22
be changed.
• If the humidity is high, Air Purifying Operation will be
carried out.
• If the air is clean and the set humidity has been reached
(during Humidifying Operation) for about 5 minutes, the
mode automatically switches to Monitoring mode.
• Pressing
during operation will cause operation to stop.
After Humidifying Operation stops, humidifying filter drying operation may be performed automatically.
If you want to stop humidifying filter drying operation, press
Note
• The humidifier lamp lights up during Humidifying Operation.
• The room temperature may drop during Humidifying Operation.
• Splashing sounds may be heard during Humidifying Operation, but this is not a malfunction.
• If the set humidity is reached or the water supply lamp lights up during Humidifying Operation, Humidifying Operation will stop,
but Air Purifying Operation will continue.
Do not turn off the unit by removing the power supply plug during operation.
(Fire due to overheating or electric shock may result)
If you want to change the airflow
direction
Adjust the louver to the desired position.
The louver can adjust the airflow in
4 directions.
►Page 14, 15
MODE lamp
AUTO FAN
AUTO FAN
Either "
–
►Page 20
WARNING
(AUTO operation)
Humidity setting lamps
–
(Low)", "
(Standard)", or "
–
„ Room conditions and operation settings
100
100
90
90
80
80
70
70
60
60
50
50
60%
40
40
30
30
0
0
34
1
50
10
Room temperature (ºF)
again.
Operation
Approx. 70°
Approx. 80°
ECONO MODE lamp
–
(High)"
–
Blinking
50%
40%
59
15
20
68
77
25
86
30
►Page 18
►Page 35
16
Advertisement
Table of Contents
