Installing The Sub-Base; Removing The Sub-Base; Installing The Batteries - Jackson Systems WCT-32 Installation Manual

Thermostat
3
Location
The thermostat should be located in an area that
represents the ambient space temperature and
within 100 feet of the HVAC Control Module. Do
not install the thermostat in an area where drafts
are present, near the floor, behind doors or on an
external wall. Avoid placing the thermsotat in
areas where the air movement is limited, affected
by direct sunlight or other areas not typical of the
temperature in the space.
4 4

Removing the Sub-Base

Hold the sub-base with one hand, press the case
as shown below and pull the bottom of the
thermostat from the sub-base.

Installing the Sub-Base

The thermostat should be installed approximately
5 feet above the floor.
Level the sub-base for appearance and use the
wall anchors and screws provided.

Installing the Batteries

Slide the battery cover off and install two AA
batteries included with the thermostat. Install the
batteries with the positive terminals to the right as
shown. Replace the battery cover.
Press here to release
case from sub-base.
The LCD will display the time of day, the setpoint
temperature and the room temperature.
3
5
6