Hunter HVLS Installation Manual page 4

!
BEFORE YOU BEGIN
TO PREVENT SERIOUS INJURY OR DEATH:
• BEFORE installing or servicing your fan, ALWAYS disconnect the power by turning off the circuit breaker or
breakers, to the fan locations and confirm Lockout/Tagout procedures are in place. If you cannot lock the circuit
breakers in the off position, securely fasten a prominent warning device, such as a tag, to the electrical panel.
• All wiring must be in accordance with national and local electrical codes, including ANSI/NFPA 70. If you are
unfamiliar with wiring or in doubt, consult a qualified electrician.
• Do not use an extension cord with fan.
• Do not remove covers while power is on.
• Do not use improper voltage source.
All fan controls and incoming power should be installed only by qualified technicians familiar with the requirements of the National
Electrical Code and local codes. Failure to follow these guidelines will void the manufacturer's warranty.
All electrical controls are configured at the factory and are ready to use. No user adjustments are available. Follow the included
installation instructions when installing this device to ensure proper operation. Do not make any changes to any part of the fan
without first consulting Hunter Industrial. Installation is to be in accordance with ANSI/NFPA 70: National Electrical Code and local
codes.
The user is responsible for compliance with all international and National Electrical Code requirements with respect to grounding of
all equipment. Many of the parts of this unit operate at line voltage.
Before installing, servicing, or cleaning the unit, switch power off at the service panel, lock the service disconnecting means, and
confirm Lockout/Tagout procedures are in place to prevent power from being switched on accidentally. When the service disconnect
means cannot be locked, securely fasten a prominent warning sign, such as a tag, to the service panel.
To reduce the risk of electric shock, serious injury, and death, only use this unit as intended by the manufacturer. If you have any
questions, call our Technical Department at 1-844-593-FANS (3267).
CONFORMS TO UL STD 507 CERTIFIED TO CAN/CSA STD C22.2 NO. 113
5007479
4
SAFETY & PRECAUTIONS
ELECTRIC SHOCK HAZARD