Hunter HVLS Installation Manual page 35

REFERENCE
Parallel connection to achieve higher current ratings is possible with the Type RF EMI/RFI filters provided that identical
models are used and the connection allows each individual filter to share current equality.
• Two separate terminal blocks will make this easier.
• Derate each filter by 10% when connecting in a parallel configuration, and always follow the NEC or local electrical codes.
• Make ground connections first.
• For each filter to be parallel connected, precut three leads of equal
wire type and gauge to the same exact length. Connect the filter input
terminals L1, L2, and L3 to the respective terminal on a separate terminal
block. Repeat this procedure for the output terminals.
• For higher current single phase applications use an appropriately rate
three phase filter. Connect the outer terminals of the three phase filter to
the single phase connections.
Single phase applications are also available.
LINE FILTER (INTERNATIONAL ONLY)
35