Hunter HVLS Installation Manual page 12

!
BEFORE YOU BEGIN
Adjusting Downrod Length
There are three different adjustable downrod length configurations: 2.5 - 4 FT (0.77 - 1.22m) | 4.5 - 6 FT (1.38 - 1.83m) | 6.5 - 10 FT
(1.99 - 3.05m). Each configuration will be shipped from the factory in the shortest configuration but will have all necessary components for
the longest configuration. If a longer length of downrod is necessary for the install, adjust the downrod at ground level before installing
to the building structure.
How to Adjust the Downrod Length:
A
Remove the two
adjustments bolts and
hardware.
Do not install downrod with only one bolt or extend downrod beyond where both bolt holes of the inner and outer tubes line up. Do not extend
past warning sticker.
Do not adjust downrod length while downrod is mounted or when the fan is attached to the downrod. Length adjustment
should happen at the ground level.
Beware pinching the motor cable or safety cable while replacing adjustment bolts.
Mounting Adjustable Downrod: Follow mounting instructions starting on page 13.
12
ADJUSTABLE DOWNROD
B
Slide the upper and lower tubes apart until
the matching pair of adjustment holes line
up to achieve desired length.
A
C
C D
Replace the two Torque the adjustment bolts,
adjustment bolts and clockwise, to 53.8 ft-lbs., until
hardware. bolts are tightly secured.
ADJUSTMENT
HOLES
B
NOTE
Ensure that bolt is tightly secured to the
downrod and that the washer did not get hung
up on the end of the adjustment bolt, causing
the bolt to be loose.