Step 3: Motor Assembly - Hunter HVLS Installation Manual

INSTALLATION
A B
Insert retention link Align the connector from the motor with the
into fork and align downrod connector.
holes.
Twist the collar on the connector to complete the
Insert clevis pin connection. Do not force. Connectors should slide
into retention rod together as they twist.
and secure with
Be sure to twist until the connection locks.
provided clip.
Zip tie the motor cable to the safety cable to reduce
the opportunity to pinch the cable
A
B
C
18

STEP 3: MOTOR ASSEMBLY

CRUSH HAZARD. To prevent serious injury or death, ALWAYS attach the retention
cable to the fan motor and secure to the building structure on EVERY fan.
C
Lift motor up to downrod while
pushing cables into downrod.
Feed the press studs through
downrod flange.
Secure with nylon lock nuts.
(Pull excess wire and cable
through top of downrod.)
NOTE
Leave approximately
3" of slack in the
wire and the cable
at the top of the
downrod opening.
NOTE
Be sure not to pinch the
motor cable when raising the
downrod into place. A zip tie
is recommended to secure
the motor cable to the safety
cable to ensure that pinching
does not occur.
19mm
Deep socket
Or wrench