MSA ALTAIR 5X PID Operating Manual page 38

5 Operation
Other operations such as changing the combustible gas type (Methane, Butane, Propane etc.) and units (ppm
to mg/m3) are only possible using the MSA Link software.
3. Change status by pressing the q or p button.
4. Press the button to confirm and advance to next screen (next sensor).
5. Perform the sequence for all other sensors.
After setting up the last sensor the device goes to the next Setup Page.
Language Setup
This option is for setting the language of the device.
1. Press the button to enter setup.
2. Change language by pressing the q or p button.
3. Confirm with the button.
The device goes to the next Setup Page.
Time and Date Setup
This option is for setting the device time and date. The device first prompts to set the time and then it prompts for the date.
The time can be set up for either regular AM/PM or military time (through MSA Link software). AM/PM time is
the default setting.
1. Press the button to enter setup.
2. Change hours by pressing the q or p button.
3. Confirm with the button.
4. Change minutes by pressing the q or p button.
5. Confirm with the button.
The device goes to the Set Date Page.
6. Change month, date and year by pressing the q or p button and confirming with the
The device goes to the next Setup Page.
7. Confirm with the button.
The device goes to the next Setup Page.
Setting Stealth Mode
Stealth mode disables the visual, audible and vibrating alarms.
1. Press the button to change mode (ON/OFF).
2. Press the q button to go to the next page or the p button to return to previous page.
Setting Datalog Intervals
This option is for setting the intervals at which all the readings will be logged.
1. Press the button to enter setup.
ALTAIR 5X PID
US
button.
38