Configuring The Wi-Fi Connection; Alarms - PEDROLLO E1 MONO Original Instructions For Use

CONFIGURING THE WI-FI CONNECTION


This menu can be used to activate the Wi-Fi reception device so that you can communicate with the outside (e.g. via laptop
PC or smartphone).
SELECT
Open the menu
ENABLE WIFI
SELECT
ENABLE WIFI
9
ENABLE WIFI
ENABLE:NO
RESETTING TO DEFAULT SETTINGS

This menu can be used to reset the control panel parameters when you want to return to the initial factory settings.
SELECT
Open the menu
RESTORE DEF
SELECT
RESTORE DEF
9
RESTORE DEF
CONFIRM?

ALARMS

The control panel reports a range of alarms that may occur during system operation. All alarms appear on the display (AL-
LARME ) with the alarm code on the lower alphanumeric display.
XXX
EXT ALARM
and proceed as follows.
• Press the key to confirm the choice and enter the submenu
• Press the or
– OFF to deactivate Wi-Fi
– ON to enable Wi-Fi.
• Press the key to confirm the choice.
• Press the key to exit from the menu.
and proceed as follows.
• Press the key to confirm the choice and enter the submenu
• Press the key to confirm that you want to reset the parameters and return the
control panel to the initial factory configuration.
• Press the key to exit from the menu.
If the control panel is in the ON state, i.e the pumps are enabled, and AL EXT is closed with
a NO voltage-free contact, the control panel enters the "EXT ALARM" (external alarm) state.
In this state, the pumps are not stopped, but are left running, and at the same time the EXT
ALARM relay is activated to generate an external acoustic and visual alarm. This is typically
used with an alarm float to warn that the water to be emptied has reached a critical level.
key to display the following:
Continued
ENGLISH |
63