Configuring The Customised Preset Mode - PEDROLLO E1 MONO Original Instructions For Use

CONFIGURING THE INPUTS AND OUTPUTS

This menu is used to configure the control panel inputs and outputs. The type and operating range of the pressure transduc-
ers, the sensitivity of the capacitive level sensors and the external alarm input and output can be set.
• Open the menu
INOUT CONFIG
• See PARAMETER EDITING COMMANDS for how to edit the values of each individual parameter.
SELECT
INOUT CONFIG
9
INOUT CONFIG
IN ALARM:ON
INOUT CONFIG
OUT ALARM:ON
INOUT CONFIG
LEVEL SENS:50
INOUT CONFIG
P.TYPE:4-20mA
INOUT CONFIG
P.RANGE:16bar

CONFIGURING THE CUSTOMISED PRESET MODE


This menu is used to choose the control panel automatic operating mode according to the requirements of the system to be
implemented.
You can choose from six different preset configurations
• Open the menu
MODE CONFIG
• See PARAMETER EDITING COMMANDS for how to edit the values of each individual parameter.
56 | ENGLISH
SELECT
• Press the
• Enable or disable the external alarm with acoustic and/or visual function.
• This alarm does not block electric pump operation, but signals a fault due to external
factors.
Default ON
• Enable or disable the relay output (NO/NC), to be used to power a siren and/or flash-
ing light.
Default ON
• Set the percentage sensitivity of the level sensor.
• This value should be calibrated for the conductivity of the water in the system.
Default 50%
• Select the pressure transducer type:
– 4–20 mA amperometric
– 0–10 V ratiometric
Default 4–20 mA
• Select the maximum operating pressure of the pressure transducer.
Default 16 bar
SELECT
key to confirm the choice and enter the submenu
Range OFF–ON
Range OFF–ON
Range 1–100%
Range 4–20 mA / 0–10 V Step /
Range 10–40
Step /
Step /
Step 1%
Step 10/16/25/40