Multifunction electric control panel for electric pumps. (164 pages)
Summary of Contents for PEDROLLO EVOLUTION Series
Page 1
QuADRO ELETTRIcO PER uN MOTORE cON cONTROLLO DEL cOS-ø cONTROL PANEL wITh cOS-ø cONTROL MADE IN ITALY PEDROLLO S.p.A. Via E. Fermi, 7 – 37047 San Bonifacio - (Verona) - Italy Tel. +39 045 6136311 – Fax +39 045 7614663 e-mail: sales@pedrollo.com – www.pedrollo.com...
Page 2
EN – OPERATING INSTRucTIONS INDEX SyMBOLS ANd wARNINGS Pag. GENERAL INFORMATION Pag. wARNINGS Pag. TEChNICAL ChARACTERISTICS Pag. INSTALLATION Pag. FRONT PANEL Pag. FuNCTIONS ANd PROGRAMMING Pag. ALARMS Pag. EVOLuTION SINGLE-PhASE wIRING dIAGRAMS Pag. EVOLuTION ThREE-PhASE wIRING dIAGRAMS Pag. GENERAL CONdITIONS Pag.
1. SYMBOLS AND wARNINGS The symbols below indicate hazardous situations that may arise if the prescriptions pro- vided in this use and maintenance manual are not followed. This warning sign is used when there is a possibility of death and to indica- te an hazardous situation which may result in severe injuries or damage of goods.
2. GENERAL INfORMATION The panel must always have its manual included in the supply and the manual must be kept in a handy place available for qualified technicians in charge of use and maintenance of the system. we recommend installers/users to read the prescriptions and information in this manual be- fore using the product, in order to prevent damage or wrong use of the equipment that also voids the warranty.
Page 5
Please notify immediately or however within 5 days from delivery our retailer or PEdROLLO customer service - if purchased directly from the company - any defect or missing goods.
4. TEchNIcAL chARAcTERISTIcS • Power supply 1~50/60 hz 230V ±10% (dRyTEK-Mono); • Power supply 3~50/60 hz 400V ±10% (dRyTEK-Tri); • Normally open contact for start; • Additional normally open contact for enabling of start; • Pushbuttons for selecting operation and set up; •...
6. fRONT PANEL electric pump EVOLUTION 1 v 1.0 Multifunction visualization and programming display; Green led for load activated; Multifunction pushbutton; Arrow up pushbutton; Arrow down pushbutton; Ok pushbutton.
7. fuNcTIONS AND PROGRAMMING MAIN VISuALIZATIONS: when EVOLuTION turns on the display visualizes the following sequence: ➞ ➞ electric pump PEDROLLO Model 50Hz EVOLUTION v 1.0 www.pedrollo.com es. m/2.2 After the sequence above the display appears as follows: 230v 0.0A 1.0@...
Page 9
AcTIVATION Of ThE LOAD ON AuTOMATIc MODE: uSER PROGRAMMING: MINIMUM COS-FI 0.70@ Push the button and keep it depressed until the display shows with the buttons set the cos-fi value so that below this parameter the load will be disabled for dry running; i.e.
Page 10
RESET N. 4 TIME 20 MIN Push the button and , is displayed with the buttons set the reset time that allows the system to restart automatically after being stopped for the fourth consecutive time by the dry running motor alarm; CYCLICAL RESET (0) NO (1) YES ?: 1...
Page 11
8. ALARMS The cos-fi value detected is lower than the one programmed. Alarm! RUNNING The display flashes and the alarm output is enabled (clean NC-C- MOTOR NA contacts). The system is automatically reset according to the time set while it was being programmed. The current absorbed by the load exceeds the value program- Alarm! MOTOR med.
• Incidental causes, acts of God, i.e. fires, flooding, water or lightening; Faulty products must be returned free of charge to PEdROLLO S.p.A., who reserves the indi- sputable opinion concerning the cause of the defect. The warranty covers only product characteristics resetting and not damages to persons or goods.
PEDROLLO S.p.A. Via E. Fermi, 7 37047 - San Bonifacio (VR) States under its own responsibility that the machine: PEDROLLO trademark EVOLuTION Series Complies with the provisions of the community directives and relevant modifications: • Machinery 98/37/EEC • European directive 2006/95/EC •...