Configuring Electric Pump No .1 And/Or No. 2; Self-Learn Configuration (Wizard) - PEDROLLO E1 MONO Original Instructions For Use

• Open the menu
• Press the key to confirm the choice
• The symbol will appear on the control panel display
• Press the ON/OFF key
• Press the or key to display which electric pump to operate:
PUMP1
START?
• Press the ON/OFF
If the electric pump does not start, check its operating state and/or connection.
• The or symbol will appear on the control panel display
• The electric current, cosφ and voltage parameters will appear on the display during operation. The electric pump will stop
when the key is released.

CONFIGURING ELECTRIC PUMP No .1 and/or No. 2

-
This menu is used to configure the electric pump operating parameters.
On entering the menu, you have two options:
–enter the wizard procedure (self-learn the current, cosφ and voltage parameters)
– proceed with manual configuration in the menu using the pump rating plate data.

SELF-LEARN CONFIGURATION (WIZARD)

The configuration wizard is a guided procedure that automatically stores the electric pump current and power factor (cosφ)
in a few steps.
SELECT
Open the menu
PUMP1 CONFIG
SELECT
PUMP1 CONFIG
9 PUMP1 CONFIG
WIZARD
9
START PUMP1?
CLOSE VALVE
PRESS OK SAVE
SELECT
MANUAL
PUMP2
o
START?
key and hold it down to start the chosen electric pump.
and proceed as follows.
• Press the
• Press the
WIZARD
• Press the
• The
• Close the electric pump delivery valve until the minimum cosφ value is dis-
c:0.70
played (c).
• Wait about 20 seconds to let the cosφ parameter (c) settle, and then the
procedure will go to the next screen.
• Press the
c:0.70
key to confirm the choice and enter the submenu
key to confirm the choice and enter the submenu
key to start electric pump no. 1.
symbol will appear on the display followed by the next screen.
key to save the COSFI MIN parameter and go to the next screen.
Continued
ENGLISH |
53