Subscribe to Our Youtube Channel
Related Manuals for Spirit EL1
Summary of Contents for Spirit EL1
- Page 1 Z100 / Z300 Z500 Z700 OWNER’S MANUAL PLEASE CAREFULLY READ THIS ENTIRE MANUAL BEFORE OPERATING YOUR NEW ELLIPTICAL!
-
Page 2: Table Of Contents
Table of Contents Product Registration Important Safety Instructions Important Electrical Information Important Operation Instructions Assembly Instructions Operation of Your New Elliptical Manufacturer s Limited Warranty ...11 ..15 EL1 Elliptical... -
Page 3: Product Registration
Through your dealer, Spirit will do all we can to make your ownership experience as pleasant as possible for many years to come. The local dealership where you purchased this elliptical is your administrator for all Spirit warranty and service needs. -
Page 4: Important Safety Instructions
Damage to both elliptical . There are obvious pinch points and other elliptical for any purpose other than for the purpose it is . Quality athletic shoes are recommended to avoid leg fatigue. EL1 Elliptical... -
Page 5: Important Electrical Information
Pushing harder is not going to make the unit go faster or slower. If you feel the buttons are not functioning properly with normal pressure, contact your Spirit dealer. to rain or moisture. This product is NOT designed for EL1 Elliptical... - Page 6 Hex Head Bolt (6pcs) 5/16" x 15m/m Hex Head Bolt (2pcs) Wave Washer (2pcs) 3/8" x 7T Nylon Nut (2 pcs) 5/16" x 20 x 1.5T Flat Washer (4 pcs) 5/16 x 3/4" Button Head Socket Bolt (2 pcs) EL1 Elliptical...
- Page 7 Step 4 3.5x12m/m Self Tapping Screw (8pcs) Tools 12m/m Wrench ( 1pc) M5 x 15m/m Phillips Head Screw (8pcs) Combination M5 Allen Wrench & Phillips Head Screw Driver (1 pc) 13/14m/m Wrench ( 2pcs) EL1 Elliptical...
-
Page 8: Assembly Instructions
Head Screws and install, and tighten, in the threaded holes in the ends of the axle. 4. Install the Left and Right Handle Bars into the Lower Left and Right Handle Bars with 6pcs of 5/16 x15m/m Button Head Socket Screws by using the Combination M5 Allen Wrench & Phillips Head Screw Driver. EL1 Elliptical... - Page 9 Handle Bars axle connections with the 6 pcs of 3.5x12m/m Self Tapping Screws by using Phillips Head Screw Driver. PLEASE ENSURE ALL FASTENERS ARE TIGHT AFTER THE COMPONENTS HAVE BEEN ASSEMBLED. POWER CONNECTOR LOCATED ON FRONT, LEFT HAND SIDE OF UNIT. EL1 Elliptical...
- Page 10 Assembly drawing step 1 EL1 Elliptical...
- Page 11 2 EL1 Elliptical...
- Page 12 3 EL1 Elliptical...
- Page 13 4 EL1 Elliptical...
-
Page 14: Operation Of Your New Elliptical
The odometer will remain displayed for only a few seconds, then the console will go to the start up display. The dot matrix display will be scrolling through the different workout profiles of the programs and the message window will be scrolling the start up message. You may now begin to use the console. EL1 Elliptical... -
Page 15: Console Operation
This is because every person is different and burns calories at a different rate. Some good news is that you will continue to burn calories at about the same rate as during exercise for an hour or more after you have finished exercising! EL1 Elliptical... - Page 16 The initial built-in level of difficulty for each program is set to a relatively easy level. You may adjust the level of difficulty for each program before beginning by following the instructions in the message window after selecting your program. EL1 Elliptical...
- Page 17 6. Now you are finished editing the settings and can begin your workout by pressing the Start key. You can also go back and modify your settings by pressing Stop key to go back one level, or screen. EL1 Elliptical...
- Page 18 4. Next is Time. You may adjust the Time and press enter to continue. 5. Now you are asked to adjust the Max Level. This is the peak exertion level you will experience during the program. Adjust the level and then press enter. EL1 Elliptical...
- Page 19 5. Now the first column will be blinking and you are asked to adjust the level for the first segment of the workout. When you finish adjusting the first segment, or if you don t want to change, EL1 Elliptical...
- Page 20 Display key. 10. When the program ends the message window will show a summary of your workout. The summary will be displayed for a short time, then the console will return to the start-up display. (optional chest strap required) EL1 Elliptical...
- Page 21 Key tone (Turn on or off the beep when a key is pressed) d. Security (Allows you to lock the keypad so no unauthorized use is allowed) Press the Start & Enter Key for 3 seconds to unlock for use. EL1 Elliptical...
-
Page 22: Manufacturer S Limited Warranty
3. If there is a question as to where to obtain service, contact our service department at (870) 935-1107. 4. If no local service is available, Spirit will repair or replace the parts, at Spirit s option, within the warranty period at no charge for parts.
Need help?
Do you have a question about the EL1 and is the answer not in the manual?
Questions and answers