Speed Selection; Fixed Speed - Linx 5900 Manual

How To Change the System Setup

2.2.1 Speed Selection

Use the Speed Selection page to select the measurement method.
You can use any of the following settings:

Fixed Speed

You tell the printer the line speed, and the printer prints at the correct rate.
Shaft Encoder
Use a shaft encoder to make sure that the print speed matches the line speed.
Dual Trigger
Use the time difference between two trigger devices to continuously measure the line
speed.
2.2.2 Fixed Speed
This option is not displayed unless you set the Speed Selection option to 'Fixed Speed'. Use
this option to enter the value for the line speed. If you do not know the line speed, see
'Calculate Line Speed' below.
19
Figure 6. Speed Selection page
Page 7 of 19
69140
FA69342–2 English
Jun 2013