CHAPTER 1: HEADLINE
CHAPTER 5: ALERTWERKS PLUS MQTT CONFIGURATION
5.1 CONFIGURATION PAGE
To configure your AlertWerks Plus device:
1.
Open Settings page -> MQTT.
2.
Click on the check box to the left of Enable MQTT to select it.
Click on the check box to the left of Broadcast sensor values periodically to select it.
3.
4.
Set the broadcast interval by entering a value between 1-60 minutes in the corresponding field.
NOTE: Set 1 minute for quick updates and testing.
5.
Set the network interface which MQTT will broadcast on by choosing a selection from the drop-down list box.
For wired networks, choose Ethernet. GSM (Modem) is also supported.
Figure 5-1 shows these options.
10
FIGURE 5-1: MQTT CONFIGURATION PAGE
1.877.877.2269
1.877.877.2269
BLACKBOX.COM
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269