Advertisement
3. Make sure that there are no cracks or deformation
on the 4 vibration damping units.
4. Replace the vibration damping units if they are
damaged.
5. Install the product to the bottom plate.
6. Install and tighten the 4 nuts and washers that hold
the vibration damping units.
To do a check of the V-belt
WARNING:
without the V-belt cover installed.
1. Stop the engine. Refer to
page 11 .
2. Loosen and remove the 6 screws on the V-belt
cover. Remove the V-belt cover.
16
Do not operate the product
To stop the product on
3. Examine the V-belt for damages and wear. Replace
the V-belt if it is necessary.
4. Examine the tension of the V-belt.
5. If the tension is not sufficient, do these steps:
a) Loosen the 4 bolts that hold the engine to the
bottom plate.
1742 - 002 - 04.02.2022
Advertisement
