Advertisement
3. Fill with new oil for the eccentric element (B). Refer
Technical data on page 19 .
to
4. Install the oil drain plug and tighten it.
5. Do a check of the oil level for the eccentric element.
To drain the oil for the eccentric
element
1. Put a container below the drain plug for the eccentric
element
2. Remove the oil drain plug (A).
3. Tilt the product and let the oil run out into the
container (B).
4. Clean the sealing surface.
5. Install the oil drain plug and tighten it.
14
A
To replace the oil filter
1. Remove the cap (A).
A
D
2. Remove the spring (B) and the oil filter (C).
3. Use diesel fuel to clean the oil filter.
4. Clean and dry the contact surfaces between the
parts.
5. Install the oil filter and the spring.
6. Examine the O-ring (D) for damages. If it is
necessary, replace the O-ring.
B
7. Install the cap.
Air filter
WARNING:
protection when you clean or replace the air
filter. Discard used air filters correctly. The
dust in the air filter is dangerous to your
health.
CAUTION:
air filter, or the dust will go into the engine
and cause engine damage.
To clean or replace the air filter
WARNING:
with compressed air. This causes damage to
the air filter and the risk increases that you
breathe the dangerous dust.
1. Open the clip on the air filter cover (A) and remove
the air filter cover.
C
B
Use approved respiratory
Always replace a damaged
Do not clean the air filter
1742 - 002 - 04.02.2022
Advertisement
