Selection And Notes On Ordering; Selection Of A Compact Safety Light Curtain Or Light Grid - Leuze lumiflex Compact C14 Series Connecting And Operating Instructions

9

Selection and Notes on Ordering

9.1

Selection of a COMPACT Safety Light Curtain or Light Grid

1. Consult the applicable regulations for the application in question (e.g. machine-specific C-Stand-
ards of the EU, or OSHA and ANSI standards in the USA), observe the notes on safety given in
Chapter 2.
2. Define the protection target and select the appropriate COMPACT model accordingly (e.g. finger
protection at a hazard location => C14, refer to Chapters 1.4 and 2.2 for this)
3. Calculate the clearance according the Chapter 4.
4. Determine the width for the protection zone; curtains on more than one front can be realised by
using deflection mirrors (refer to 1.5).
5. Determine the protection height = height of the area to be protected or the depth for horizontal
applications (take reaching over, reaching under, crawling under etc. into consideration).
6. Select the equipment type and the ordering number from the selection table.
Types for light curtains C14 and C30 and light grids C50 and C90
Example: CT14A-1050M/W
Ca bbA-dddd e/f
C : COMPACT
a : T = Transmitter, R = Receiver
bb : Object sensitivity, resolution [mm]
A : Only at plugable connection with akkalit front plates (resistant to welding)
dddd : Protected height [mm]
e : Only for cascade connections M = master, S = Slave
f : W = plugable design with angled cable socket, DIN 43651
G = plugable design with straight cable socket, DIN 43651
BH = plugable design with „Brad-Harrison-Min" connection
Leuze lumiflex COMPACT 79