Cleaning The Print Head - AGFA Crystal-M Imager User Manual

Cleaning the print head

To clean the print head:
1. Press the Key-operator key to enter the Key-operator mode.
2. On the Key-operator main menu, press the Down key five times, followed
by the Confirm key to select 'Calibration'.
5 Restore config.
6 Calibration
7 Service Actions
8 Quality Control
9 Installation
3. On the Select calibration menu, press the Down key, followed by the
Confirm key to select 'Clean therm. head'.
4. The 'Thermal head cleaning' screen will give step-by-step instructions on
what to do:
5. Open the top cover.
6. As soon as the top cover is opened, the 'Thermal head cleaning' screen
continues giving the following instructions:
Crystal-M Imager | Preventive maintenance schedule | 123
WARNING:
Print head cleaning must be done when image quality problems
occur.
Visible
Reachable with Up/Down arrow keys
3852B EN 20210601 1655