Table of Contents
Advertisement
92 | XD 10, XD⁺10 | Getting started
Stopping the DR detector
To stop the DR detector:
1. If the DR detector is connected to the System Control Unit via the DR
detector cable, turn off the System Control Unit using the power switch.
Depending on the configuration, the DR detector will be stopped
automatically.
2. Turn off the detector.
Press and hold the power button for 3 seconds.
The power indicator light is off.
3. Put the detector in an empty slot of the DR detector cradle to charge the
battery.
Insert the DR detector with the tube side to the right.
The status indicator for the slot in which the detector is inserted, lights up
yellow. The battery is charging.
0432A EN 20210426 1355
Note: When the detector will not be used for some time, remove the
battery. Otherwise, overdischarge may occur, leading to a shorter
battery life.
Note: When not in use, keep the detector, handle unit with grid in a
designated location or in a location where they are safe and cannot
fall down.
Advertisement
Table of Contents
