Advertisement
Quick Links
LED-51/52 Series
Installation Instructions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations, if
applicable.
• Do not mount near gas or electrical heaters.
• Do not use outdoors.
• Do not let power cords touch hot surfaces.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering
by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
• Allow battery to charge for 24 hours or 48 hours before first use for models with one or two batteries,
respectively.
10070204 REV 5 - 05/22
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS!
Technical Support
■ (623) 580-8943 ■ technicalsupport@barronltg.com
1
800-533-3948 www.barronltg.com
Advertisement
Related Manuals for BARRON EXITRONIX LED-51 Series
Summary of Contents for BARRON EXITRONIX LED-51 Series
- Page 1 LED-51/52 Series Installation Instructions IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS. When using electrical equipment, basic safety precautions should always be followed including the following: • DISCONNECT AC POWER SUPPLY BEFORE SERVICING. • Installation and servicing of this equipment should be performed by qualified service personnel only. •...
- Page 2 LED-51/52 Series Installation Instructions Wall/Ceiling Mount - Back Power Feed Fig. 1 1. Insert a flat blade screwdriver into the two slots to remove the front cover from the backplate. (Fig. 1) 2. Remove from the backplate the center knockout and any knockouts that are needed to mount to the J-box.
- Page 3 LED-51/52 Series Installation Instructions Electrical Connections Use Flexible Conduit Only. All electrical connections should be made inside the J-box. Make electrical connections as follows (Fig. 5): 120VAC 277VAC White - Common White - Common Black - 120VAC Orange - 277VAC Fig.
- Page 4 LED-51/52 Series Installation Instructions Self-Test/Self-Diagnostics (G2) Operation The purpose of this option is to provide Self-testing and Self-diagnostic capabilities to the emergency unit. At predetermined intervals, the emergency unit will automatically switch into battery mode. Refer to the Self-Test Feature section below for timing details.